POE Power over Ethernet module series is through non-shielded twisted-pair UTP in the eight lines of the two pairs of lines to transmit Vcc and GND, the transmission of data transmission as well as direct current, the product is reliable, easy to install. Network device-side only by a RJ45 network connection, and transmit data and power, easy to manage. Because network devices often require the use of an uninterruptible power supply (UPS) supply of electricity in the use of PoE devices, all of the network devices use a UPS on the PoE device-side protection, this can greatly reduce network construction costs. The use of PoE devices will reduce the use of the number of UPS to avoid the vicinity of each network device to install electrical outlets and greatly reduce equipment costs and management costs.
Products used in large-capacity capacitors, and a variety of high-quality components to ensure the stability of the module and high pressure, and can be different depending on equipment specifications, providing 3.3V, 5V, 7.5V, 9V, 10V, 12V, 18V, 48V . To adapt to a variety of small network devices.
This series of cable power supply module is a set based on the UTP (Unshielded Twisted Pair) cable to provide network equipment for small power supply equipment.
Increase the flexibility of fabric network, greatly simplifying the installation and configuration of wireless networks.
Product color with high-quality components and circuitry of multiple steady flow to ensure that the equipment work stable and reliable.
PD-side support by the electric voltage of 12V-48V switch to the input of various user-friendly UPS DC power supply.
POE system performance parameters
Parameter Value and Description
No-load voltage output of 3.33V ≤ V ≤ 3.34V, 5.19V ≤ V ≤ 5.23,9.02 ≤ V ≤ 9.03,12.10 ≤ V ≤ 12.20
With load voltage output drop-V ≤ 0.1V
output power with load ≤ 15W
With load ripple ≤ 50mV
Noise ≤ 70mV
10/100Mbps data transfer rate
Maximum transmission distance of 100 m (cable resistance is less than equal to 0.1 ohms / m)
Pin allocation RJ45 4 / 5 (+) 7 / 8 (-) or 4 / 5 (-) 7 / 8 (+)
Output voltage is decided by the network equipment required voltage
User Port Power is less than equal to 10W
Input Power Requirements DC 12V or 24V or 48V (depending on input voltage may be)
Maximum input power 36W
Status panel LED display
Power LED power indicator (red)
Active LED PoE power status indicator (green)
A data input connector RJ-45 cable (Data)
A data and power output, RJ-45 connectors (Data Power)
An AC power cord (220V)
A DC power cable (DC OUT)
Environmental conditions of 0 to 45 degrees Celsius
Operating temperature maximum 85%, non-condensing
Operating Humidity -25 to 85 degrees Celsius